Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota PriusFACTORY OEM SERVICE PROCEDURE
How To Proceed With Troubleshooting
HINT:
- Use these procedures to troubleshoot the smart entry system.
- The hand-held tester should be used in STEP 3 and 5.
- VEHICLE BROUGHT TO WORKSHOPÂ
NEXTÂ
- CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See  CUSTOMER PROBLEM ANALYSIS CHECK Â
)Â
NEXTÂ
- INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)Â
- Use the hand-held tester to check for normal function of the multiplex communication system.
Result:Â
RESULTResult Proceed to (ECU not connected, communication line malfunctioning) Without code outputs A (ECU not connected, communication line malfunctioning) With code outputs B - B: Go to MULTIPLEX COMMUNICATION SYSTEM (See  DIAGNOSTIC TROUBLE CODE CHART )Â
- A: GO TO NEXT STEPÂ
- PROBLEM SYMPTOMS TABLEÂ Â
Result:Â
RESULTResult Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B - B: Go to STEPÂ Â 6Â
- A: GO TO NEXT STEPÂ
- OVERALL ANALYSIS AND TROUBLESHOOTINGÂ
- On-vehicle inspection (See ON-VEHICLE INSPECTIONÂ )
- DATA LIST/ACTIVE TESTÂ
- Inspection with the hand-held tester (DATA LIST)
- Inspection with the hand-held tester (ACTIVE TEST)
- TERMINALS OF ECUÂ
NEXTÂ
- ADJUST, REPAIR OR REPLACEMENTÂ
NEXTÂ
- CONFIRMATION TESTÂ
NEXTÂ
ENDÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
