Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Data List/Active Test
- READ DATA LIST
HINT:
Using the hand-held tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Connect the hand-held tester (with CAN VIM) to the DLC3.
- Turn the power switch ON (IG) and press the hand-held tester main switch ON.
- Read the DATA LIST according to the display on the tester.
Smart key ECU:
- PERFORM ACTIVE TEST
HINT:
Performing the hand-held tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.
- Connect the hand-held tester (with CAN VIM) to the DLC3.
- Turn the power switch ON (IG) and press the hand-held tester main switch ON.
- Perform the ACTIVE TEST according to the display on the tester.
Smart key ECU:
ACTIVE TEST (SMART KEY ECU)Item Test Details Diagnostic Note D TRANSMITTER Driver side transmitter ON/OFF P TRANSMITTER Passenger side transmitter ON/OFF FR TRANSMITTER Front transmitter ON/OFF IN BDR TRNSMTTR Back door inner transmitter ON/OFF BDOOR TRNSMTTR Back door outer transmitter ON/OFF D SELECT SIG Driver side select ON/OFF P SELECT SIG Passenger side select ON/OFF
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
