Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING COLUMN ASSYOVERHAUL
2005 Toyota Matrix XR, FWD, Standard
Steering Column ASSY: Overhaul
2005 Toyota Matrix XR, FWD, StandardSECTION Overhaul
- PRECAUTION
- DISCONNECT BATTERY NEGATIVE TERMINAL
- INSPECT PLACE FRONT WHEELS FACING STRAIGHT AHEAD
- REMOVE HORN BUTTON ASSY NOTE: If the airbag connector is disconnected with the ignition switch being at ON, DTCs will be recorded.
- Using a Torx socket wrench, loosen the 2 Torx screws until the groove along the screw circumference catches on the screw case.
- Pull out the horn button assy from the steering wheel.
- Using a screwdriver, release the lock part of each airbag connector and disconnect the 2 airbag connectors.NOTE: When removing the horn button assy, take care not to pull the airbag wire harness.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.