Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2005MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMIRRORSWINDSHIELD/WINDOWGLASS/MIRRORPOWER WINDOW CONTROL SYSTEMON-VEHICLE INSPECTION

2005 Toyota Matrix XR, FWD, Standard

On-Vehicle Inspection

2005 Toyota Matrix XR, FWD, StandardSECTION On-Vehicle Inspection

CHECK BASIC FUNCTION (MANUAL OPERATION FUNCTION)
1. Turn the ignition switch ON.
  1. Check that a door glass moves up when its respective window switch of the regulator master switch assembly is pulled up, and moves down when its respective window switch is pushed down.
  2. Check that a door glass moves up when the window switch of each regulator switch assembly is pulled, and moves down when each window switch is pushed down.
  3. Check that only the driver's door glass can operate when the window lock switch is pressed.
CHECK AUTOMATIC OPERATION FUNCTION
1. Turn the ignition switch ON.
  1. Check that a door glass is fully opened when each window switch of the regulator master switch assembly is fully pressed DOWN.
  2. Check that a door glass is fully opened when the window switch of each regulator switch assembly is fully pressed DOWN.
  3. Check that the door glass stops when the applicable switch is turned UP during the AUTO DOWN operation. (However, if the switch is kept on the UP side, the window will change to the manual operation.)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.