Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSTOYOTA2005ECHO L4-1.5L (1NZ-FE)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSDIAGRAMSDIAGNOSTIC AIDSHOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMSDIAGNOSTIC TROUBLE CODE CHART
2005 Toyota Echo L4-1.5L (1NZ-FE)
Diagnostic Trouble Code Chart
2005 Toyota Echo L4-1.5L (1NZ-FE)SECTION Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART

The inspection procedure is shown in the table. This table permits efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code check. Proceed with troubleshooting in accordance with the inspection procedure given in the diagnostic chart corresponding to the diagnostic trouble codes displayed. The engine diagnostic trouble code chart is shown as an example.
The inspection procedure is shown in the table. This table permits efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code check. Proceed with troubleshooting in accordance with the inspection procedure given in the diagnostic chart corresponding to the diagnostic trouble codes displayed. The engine diagnostic trouble code chart is shown as an example.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.