Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005ECHO L4-1.5L (1NZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINETIMING COMPONENTSSYSTEM SPECIFICATIONS
2005 Toyota Echo L4-1.5L (1NZ-FE)
System Specifications
2005 Toyota Echo L4-1.5L (1NZ-FE)SECTION System Specifications
Crankshaft Pulley
Using SST, install the pulley bolt.
Torque 128 Nm (1,300 kgf-cm, 94 ft. lbs.)
Timing Cover
Install the timing chain cover, new O-ring and water pump with the 16 bolts and 3 nuts. Uniformly tighten the bolts and nut in several passes.
Torque:
Bolt A 11 Nm (113 kgf-cm, 8 ft. lbs.)
Bolt B 24 Nm (245 kgf-cm, 18 ft. lbs.)
Bolt C 11 Nm (113 kgf-cm, 8 ft. lbs.)
Bolt D 24 Nm (245 kgf-cm, 18 ft. lbs.)
Bolt E 11 Nm (113 kgf-cm, 8 ft. lbs.)
Nut F 24 Nm (245 kgf-cm, 18 ft. lbs.)
Nut G 11 Nm (113 kgf-cm, 8 ft. lbs.)
Using SST, install the pulley bolt.
Torque 128 Nm (1,300 kgf-cm, 94 ft. lbs.)
Timing Cover
Install the timing chain cover, new O-ring and water pump with the 16 bolts and 3 nuts. Uniformly tighten the bolts and nut in several passes.
Torque:
Bolt A 11 Nm (113 kgf-cm, 8 ft. lbs.)
Bolt B 24 Nm (245 kgf-cm, 18 ft. lbs.)
Bolt C 11 Nm (113 kgf-cm, 8 ft. lbs.)
Bolt D 24 Nm (245 kgf-cm, 18 ft. lbs.)
Bolt E 11 Nm (113 kgf-cm, 8 ft. lbs.)
Nut F 24 Nm (245 kgf-cm, 18 ft. lbs.)
Nut G 11 Nm (113 kgf-cm, 8 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.