Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005ECHO L4-1.5L (1NZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD, ENGINE
2005 Toyota Echo L4-1.5L (1NZ-FE)
Connecting Rod, Engine
2005 Toyota Echo L4-1.5L (1NZ-FE)SECTION Connecting Rod, Engine
Connecting Rod Thrust Clearance
Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth.
Standard thrust clearance 0.16 - 0.36 mm (0.0063 - 0.0142 inch)
Maximum thrust clearance 0.36 mm (0.0142 inch)
Connecting Rod Oil Clearance
Install the connecting rod cap with the 2 bolts.
Torque:
1ST 15 Nm (150 kgf-cm, 11 ft. lbs.)
2ND Turn 90°
Measure the Plastigage at its widest point.
Standard oil clearance 0.016 - 0.040 mm (0.0006 - 0.0016 inch)
Maximum oil clearance 0.06 mm (0.0024 inch)
Connecting Rod Cap
Install the connecting rod cap with the 2 bolts.
Torque:
1ST 15 Nm (150 kgf-cm, 11 ft. lbs.)
2ND Turn 90°
Measure the Plastigage at its widest point.
Standard oil clearance 0.016 - 0.040 mm (0.0006 - 0.0016 inch)
Maximum oil clearance 0.06 mm (0.0024 inch)
Connecting Rod Alignment
Check for misalignment
Maximum misalignment 0.05 mm (0.0020 inch) per 100 mm (3.94 inch)
Check for twist
Maximum twist 0.05 mm (0.0020 inch) per 100 mm (3.94 inch)
Connecting Rod Bolts
Standard diameter 6.6 - 6.7 mm (0.260 - 0.264 inch)
Minimum diameter 6.4 mm (0.252 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.