Programming and Relearning

ADD ADDITIONAL REMOTE CONTROL(S) TO SYSTEM
Follow this procedure to add additional remote controls to a system. The RS3200 may be programmed to operate with a maximum of four remote controls. When a new remote controls is programmed, it will work in the default operation mode (press the UNLOCK button twice to unlock all doors and no AUX button function on 4 button remote controls); to change the operation mode, you must perform the separate REMOTE CONTROL FUNCTION SELECT procedure.








REPROGRAM EXISTING REMOTE CONTROLS
Follow this procedure to clear all existing remote control codes and reprogram existing remote controls to a system. When existing remote controls are reprogrammed, they will work in the default operation mode (press the UNLOCK button twice to unlock all doors and no AUX button function on 4 button remote controls); to change the operation mode, you must perform the separate REMOTE CONTROL FUNCTION SELECT procedure.








REMOTE CONTROL FUNCTION SELECT
Follow this procedure to change the operating functions of remote controls already programmed into a system. You may change the remote controls default unlock operation mode so that pressing the UNLOCK button once causes all doors to unlock at the same time. Also, you may activate the AUX button function on 4 button remote controls.





CLEAR ALL REMOTE CONTROL CODES
Follow this procedure to clear all remote controls programmed to operate the system. Please note, if you have remote controls to program into the system and you want to first clear all existing remote controls from the system, follow the reprogram procedure in REPROGRAM EXISTING REMOTE CONTROLS.





PASSIVE ARMING ON/OFF SELECTION AND ENTRY DELAY TIME SELECTION
The RS3200 is factory set to not passively arm. To change the system's operation for passive arming, as well as to adjust the entry delay time, follow the procedure above.





IGNITION-CONTROLLED AUTOMATIC DOOR LOCK/UNLOCK
When all doors are closed, the RS3200 is factory set to automatically lock the vehicle's door when the ignition key is turned to ON or START, and unlock them (open or not) when the key is turned back to ACC or LOCK. Follow the procedure below to change this feature's operation mode.





PASSIVE ARMING ON/OFF SELECTION AND ENTRY DELAY TIME SELECTION
The RS3200 PLUS is factory set to not passively arm. To change the system's operation for passive arming, as well as to adjust the entry delay time, follow the procedure above.