Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005ECHO 2D SEDAN, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOEM GENERAL INFORMATIONSERVICE SPECIFICATIONSCHARGING SYSTEMTORQUE SPECIFICATIONS
2005 Toyota ECHO 2D Sedan, Standard
Torque Specifications
2005 Toyota ECHO 2D Sedan, StandardSECTION Torque Specifications
CHARGING TORQUE SPECIFICATIONS
| Part tightened | N.m | kgf.cm | ft.lbf | |
|---|---|---|---|---|
| Bearing retainer at Drive end frame | 3.0 | 31 | 27 in.lbf | |
| Rectifier end frame without wire clip at Drive end frame | 4.5 | 46 | 40 in.lbf | |
| Rectifier end frame with wire clip at Drive end frame | 5.4 | 55 | 48 in.lbf | |
| Alternator pulley at Rotor | 111 | 1,125 | 81 | |
| Rectifier holder at Lead wire on rectifier end frame | 2.9 | 30 | 26 in.lbf | |
| IC regulator at Rectifier holder | 2.0 | 20 | 17 in.lbf | |
| IC regulator at Rectifier holder | 2.0 | 20 | 17 in.lbf | |
| Brush holder at Rectifier holder | 2.0 | 20 | 17 in.lbf | |
| Brush holder at IC regulator | 2.0 | 20 | 17 in.lbf | |
| Rear end cover at Rectifier holder | Nut | 4.4 | 45 | 39 in.lbf |
| Bolt | 3.9 | 39 | 35 in.lbf | |
| Terminal insulator at Rectifier holder | 4.1 | 42 | 36 in.lbf | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.