Camshaft Position Sensor: Removal

2005 Toyota ECHO 2D Sedan, StandardSECTION Removal
  1. Disconnect the connector.
  2. Remove the bolt and camshaft position sensor.

    Torque: 8.0 N.m (82 kgf.cm, 71 in..lbf) 

    Fig 1: Disconnecting Connector
    G02575094Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.