Engine Mechanical: Equipment

2005 Toyota ECHO 2D Sedan, StandardSECTION Equipment
ENGINE MECHANICAL EQUIPMENT

Abrasive compound Valve
Caliper gauge  
CO/HC meter  
Compression gauge  
Connecting and aligner  
Cylinder gauge  
Dial indicator  
Dye penetrant  
Engine tune-up tester  
Groove cleaning tool Piston ring groove
Heater  
Magnetic finger  
Micrometer  
OBDII scan tool  
Pin hole grinder Piston pin hole of piston
Piston ring compressor  
Piston ring expander  
Plastigage  
Precision straight edge  
Press  
Ridge reamer Cylinder
Soft brush  
Spring tester Valve spring
Steel square Valve spring
Thermometer  
Torque wrench  
Torx wrench socket set Stud bolt
Valve seat cutter  
V-block  
Vernier calipers  
Wire brush Valve
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.