Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005ECHO 2D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESWHEEL HUBSSUSPENSION AND AXLEREAR AXLE BEAMREPLACEMENT
2005 Toyota ECHO 2D Sedan, Standard
Rear Axle Beam: Replacement
2005 Toyota ECHO 2D Sedan, StandardSECTION Replacement
- REMOVE BUSHING
- Place matchmarks on the 2 notches of the bushing and axle beam.
- Using a chisel and hammer, bend the 2 portions of the bushing rib.NOTE: Bend the bushing rib until the claw of SST can be hung.
- Using SST, remove the bushing from the axle beam.
SST 09309-37010,09950-40011 (09951-04010,09952-04010, 09953-04010, 09954-04020, 09955-04051,09957-04010, 09958-04011)
NOTE: If the axle beam has been scratched, apply the paint.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.