SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005CELICA GT-S, STANDARDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSCHARGING SYSTEMGENERATORREMOVAL
2005 Toyota Celica GT-S, Standard

Charging System: Generator: Removal

2005 Toyota Celica GT-S, StandardSECTION Removal
  1. REMOVE DRIVE BELT 
    1. Turn the drive belt tensioner clockwise to relieve tension on the belt, and then remove the belt.
    2. Carefully return the tensioner to the unloaded position.
    Fig 1: Removing Drive Belt
    G02601013Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE GENERATOR 
    1. Disconnect the wire clamp from the wire clip on the rectifier end frame.
    2. Remove the rubber cap and nut, and disconnect the generator wire.
    3. Disconnect the generator connector.
      Fig 2: Disconnecting Wire Clamp From Wire Clip On Rectifier End Frame
      G02601014Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. 2ZZ-GE:

      Remove the 2 bolts and generator bracket.

    5. Remove the 2 bolts and generator.
    Fig 3: Removing Generator
    G02601015Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.