Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005CELICA GT-S, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONOEM GENERAL INFORMATIONSERVICE SPECIFICATIONSSTARTING SYSTEMTORQUE SPECIFICATION
2005 Toyota Celica GT-S, Standard
Torque Specification
2005 Toyota Celica GT-S, StandardSECTION Torque Specification
TORQUE SPECIFICATION
| Part tightened | N.m | kgf.Cm | ft.lbf |
|---|---|---|---|
| Starter x Transaxle | 37 | 380 | 28 |
| End cover x Brush holder | 3.8 | 39 | 34 in.lbf |
| Starter housing x Magnetic switch | 9.3 | 95 | 82 in.lbf |
| End cover x Starter housing | 9.3 | 95 | 82 in.lbf |
| Lead wire x Terminal C of starter | 5.9 | 60 | 52 in.lbf |
| Terminal nut x Terminal C of starter, Terminal 30 of starter | 17 | 173 | 12 |
| Magnetic switch end cover x Magnetic switch | 2.5 | 26 | 23 in.lbf |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.