Service Data

2005 Toyota Celica GT-S, StandardSECTION Service Data
Starting Service Data List

Starter Rated voltage and output power 12 V 1.4 kW
    12 V 1.2 kW
No-load characteristics Current 90 A or less at 11.5 V
rpm 3, 000 rpm or more
Brush length STD 15.5 mm (0.610 in.)
Minimum 10.0 mm (0.394 in.)
Spring installed load STD  
1.4 kW 17.6 -- 23.5 N (1.8 -- 2.4 kgf, 4.0 -- 5.3 lbf)
1.2 kW 13.7 -- 19.6 N (1.4 -- 2.0 kgf, 3.1 -- 4.6 lbf)
Minimum  
1.4 kW 11.8 N (1.2 kgf, 2.6 lbf)
1.2 kW 8.8 N (0.9 kgf, 2.0 lbf)
Commutator  
Diameter STD 30.0 mm (1.181 in.)
Minimum 29.0 mm (1.412 in.)
Undercut depth STD 0.6 mm (0.024 in.)
Minimum 0.2 mm (0.008 in.)
Circle runout Maximum 0.05 mm (0.0020 in.)
Magnetic switch  
Contact plate for wear Maximum 0.9 mm (0.035 in.)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.