SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005CELICA GT-S, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSCHARGING SYSTEM (SERVICE SPECIFICATIONS)CHARGING SYSTEMTORQUE SPECIFICATION
2005 Toyota Celica GT-S, Standard

Torque Specification

2005 Toyota Celica GT-S, StandardSECTION Torque Specification
TORQUE SPECIFICATION

Part tightened N.m kgf.Cm ft.lbf
Bearing retainer x Drive end frame 3.0 31 27 in.lbf
Rectifier end frame x Drive end frame Nut A
Nut B		 4.5
5.4		 46
55		 40 in.lbf
48 in.lbf
Generator pulley x Rotor 111 1, 125 81
Rectifier end frame x Brush holder, Voltage regulator 2.0 20 17 in.lbf
Rectifier holder x Coil lead on rectifier end frame 2.9 30 25 in.lbf
Rear end cover x Rectifier holder 4.4 45 39 in.lbf
Plate terminal x Rectifier holder Nut
Bolt		 4.4
3.9		 45
39		 39 in.lbf
35 in.lbf
Terminal insulator x Rectifier holder 4.1 42 36 in.lbf
Generator x RH engine mount bracket 25 20 18
Generator x Cylinder block 1ZZ-FE
2ZZ-GE		 54
58		 550
590		 40
43
Generator x Generator bracket 29 295 21
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.