Inspection Procedure

2005 Toyota 4Runner Sport, 4.7 T, RWDSECTION Inspection Procedure
  1. CHECK MANUAL UP/DOWN FUNCTION (DRIVER SIDE) 
    1. Check that the door glass can be operated manually.
    1. NG: OTHER PROBLEM (See MANUAL UP/DOWN FUNCTION DOES NOT OPERATE ON DRIVER SIDE  )

    OK: Go to next step. 

  2. CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSY 
    1. Turn the ignition switch ON.
    2. Operate the power window switch on the driver side.
    3. Check the blinking pattern of the illumination as shown in the illustration.
      1. If the switch indicates (1), proceed to A.
      2. If the switch indicates (2) or (3), proceed to B.
      3. If the switch indicates normal, proceed to C.
      Fig 1: Locating Power Window Switch
      G02577789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.