SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20054RUNNER SR5, 4.7 T, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO SYSTEM & VISUAL SYSTEMRADIO RECEIVER ASSYREPLACEMENT
2005 Toyota 4Runner SR5, 4.7 T, AWD

Radio Receiver ASSY: Replacement

2005 Toyota 4Runner SR5, 4.7 T, AWDSECTION Replacement

HINT:

COMPONENTS 

  1. REMOVE INSTRUMENT PANEL FINISH PLATE (See  REPLACEMENT  ) 
  2. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSY LOWER (See  REPLACEMENT  ) 
  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY (See  REPLACEMENT  ) 
  4. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSY (See  REPLACEMENT  ) 
  5. REMOVE CONSOLE PANEL SUB-ASSY UPPER (See  REPLACEMENT  ) 
  6. REMOVE AIR CONDITIONING CONTROL ASSY (See  REPLACEMENT  ) 
  7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY CENTER (See  REPLACEMENT  ) 
  8. REMOVE RADIO RECEIVER ASSEMBLY W/BRACKET 
    1. Remove the 2 bolts.
    2. Disconnect the connectors and remove the radio receiver assembly w/bracket.
    Fig 1: Removing Radio Receiver Assembly
    G02574128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE RADIO BRACKET NO. 1 
    1. Remove the 4 screws and radio bracket No. 1.
    Fig 2: Removing 4 Screws And Radio Bracket No. 1
    G02574129Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE RADIO BRACKET NO. 2 
    1. Remove the 4 screws and radio bracket No. 2.
    Fig 3: Removing 4 Screws And Radio Bracket No. 2
    G02574130Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.