Front No. 1 Speaker ASSY: Replacement

2005 Toyota 4Runner SR5, 4.7 T, AWDSECTION Replacement

HINT:

COMPONENTS 

  1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH(See  OVERHAUL  ) 
  2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH(See  OVERHAUL  ) 
  3. REMOVE FRONT ARMREST ASSY LH(See  OVERHAUL  ) 
  4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSY LH(See  OVERHAUL  ) 
  5. REMOVE FRONT NO. 1 SPEAKER ASSY 
    1. Disconnect the connector.
    2. Remove the 4 screws and front No. 1 speaker assy.
    Fig 1: Removing Screws And Front No. 1 Speaker Assy
    G02574131Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL FRONT NO. 1 SPEAKER ASSY 
    1. Install the front No. 1 speaker assy with the 4 screws.
      NOTE: Install them in the order shown in the illustration.
    2. Connect the connector.
    Fig 2: Installing Front No. 1 Speaker Assy
    G02574132Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.