Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA20054RUNNER SR5, 4.7 T, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALAUXILIARY EMISSION CONTROL SYSTEMSEMISSION CONTROL SYSTEMCHARCOAL CANISTER ASSY (2UZ-FE)REPLACEMENT

2005 Toyota 4Runner SR5, 4.7 T, AWD

Charcoal Canister ASSY (2UZ-FE): Replacement

2005 Toyota 4Runner SR5, 4.7 T, AWDSECTION Replacement

REMOVE SPARE TIRE

Fig 1: Disconnecting Canister Outlet Hose
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CHARCOAL CANISTER ASSY
1. Disconnect the fuel tank vent hose from the charcoal canister.
  1. Deeply push the connector inside.
  2. Pinch portion A.
  3. Pull out the connector.
2. Disconnect the canister outlet hose No. 2 from the charcoal canister.
  1. Deeply push the connector inside.
  2. Pinch portion A.
  3. Pull out the connector.
3. Disconnect the VSV connector form the CCV.
4. Disconnect the purge line hose from the charcoal canister.
5. Remove the 3 bolts, and the charcoal canister from the body.
INSTALL CHARCOAL CANISTER ASSY
1. Install the charcoal canister with the 3 bolts.
  Torque: 20 N.m (204 kgf.cm, 15 ft.lbf)
2. Connect the purge line hose to the charcoal canister.
3. Connect the VSV connector to the CCV.
4. Connect the canister outlet hose No. 2 to the charcoal canister.
5. Connect the fuel tank hose to the charcoal canister.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.