How To Proceed With Troubleshooting

2005 Toyota 4Runner SR5, 4.7 T, AWDSECTION How To Proceed With Troubleshooting

HINT:

Troubleshoot in accordance with the procedures in the following examples.

  1. VEHICLE BROUGHT TO WORKSHOP 

    Go to next step. 

  2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See  CUSTOMER PROBLEM ANALYSIS CHECK   ) 

    Go to next step. 

  3. PROBLEM SYMPTOMS TABLE  

    Go to next step. 

  4. PERFORM TROUBLESHOOTING 
    1. PRE-CHECK 
    2. Circuit inspection (See AUTO UP/DOWN FUNCTION DOES NOT OPERATE  - POWER WINDOWS DO NOT OPERATE AT ALL  )

    Go to next step. 

  5. ADJUST, REPAIR OR REPLACE 

    Go to next step. 

  6. RESET POWER WINDOW MOTOR 
    1. If any of the power window switch illuminations is blinking after repair, reset the power window.
      1. Turn the ignition switch ON.
      2. Open the driver side door glass.
      3. Fully pull up the AUTO switch of the power window master switch until the door glass is fully closed.
      4. Check that the AUTO UP/DOWN function operates normally.

    Go to next step. 

    END 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.