Inspection Procedure

1. Check if the radio auto-search function properly.
   1. Perform the auto-research of the radio and check that the operation is normal.

      Standard: malfunction disappear. 

1. NG: Go to step   5 

OK: Go to next step. 

1. Press "EJECT" and check the operation.
   1. Press the cassette tape EJECT switch of the radio receiver assembly for 2 sec. or more and check that the cassette tape is ejected.

      Standard: The cassette tape is ejected. 

1. NG: CHECK AND REPLACE RADIO RECEIVER ASSY 

OK: Go to next step. 

1. Check the cassette tape.
   1. Check that the ejected cassette tape does not have the label peeling, cassette body deformation and others.

      Standard: No fault on the cassette tape. 

1. NG: CASSETTE TAPE FAULTY 

OK: Go to next step. 

1. Replace the cassette tape with another and recheck.
   1. Replace the faulty cassette tape with the normal one to see if the same trouble occurs again.

      Standard: malfunction disappear. 

1. OK: CASSETTE TAPE FAULTY 

NG: Go to next step. 

1. Check that the continuity between terminals at each condition, as shown in the chart.

   Standard: 

   TESTER CONNECTION SPECIFIED CONDITION CHART (1 OF 2)
   
   

   Tester connection	Condition	Specified condition
   GND - Body ground	Constant	Continuity

   Fig 1: Checking Continuity Between Terminals (6 Speaker (Built-In AMP))

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check that the voltage between terminals at each condition, as shown in the chart.

   Standard: 

   TESTER CONNECTION SPECIFIED CONDITION CHART (2 OF 2)
   
   

   Tester connection	Condition	Specified condition
   BU+B - GND/E	Constant	10-14V
   ACC+B - GND/E	Ignition switch ACC or ON	10-14V

   Fig 2: Checking Voltage Between Terminals (Except 6 Speaker (Separate AMP))

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. OK: CHECK AND REPLACE RADIO RECEIVER ASSY 

NG: Go to next step. 

REPAIR OR REPLACE HARNESS OR CONNECTOR