Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENTREAR SUSPENSION SYSTEMREAR SHOCK ABSORBER WITH COIL SPRING (4WD)DISPOSAL
2004 Toyota Matrix XR, FWD, Standard
Rear Shock Absorber With Coil Spring (4WD): Disposal
2004 Toyota Matrix XR, FWD, StandardSECTION Disposal
- DISPOSE OF SHOCK ABSORBER ASSY REAR LH
- Fully extend the shock absorber rod.
- Using a drill, make a hole in the cylinder as shown in Fig 1 to discharge the gas inside the cylinder.
CAUTION:- When drilling, since fragments may fly out, work carefully.
- The discharged gas is colorless, odorless and non-poisonous.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.