SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 15 (AUTOMATIC TRANSMISSION (ON-VEHICLE SERVICE))SPEEDOMETER SENSOR (A246E)REPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Speedometer Sensor (A246E): Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different variant/trim than selected.
  1. REMOVE AIR CLEANER CASE 
  2. REMOVE AIR CLEANER HOSE NO.1 
  3. REMOVE SPEEDOMETER SENSOR 
    1. Disconnect the connector.
    2. Remove the bolt and speedometer sensor assembly.
    3. Remove the clip and driven gear from the speedometer sensor.
      Fig 1: Removing Clip And Driven Gear From Speedometer Sensor
      G00920625Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL SPEEDOMETER SENSOR 
    1. Coat a O-ring with ATF and install it to the speedometer sensor.
    2. Install the driven gear to the speedometer sensor with the clip.
    3. Install the speedometer sensor assembly with the bolt.
      1. Torque: 11.3 N.m (115 kgf.cm, 9 ft.lbf) 
    4. Connect the connector.
  5. INSTALL AIR CLEANER HOSE NO.1 
  6. INSTALL AIR CLEANER CASE 
    1. Torque: 7.0 N.m (71 kgf.cm, 62 in.lbf) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.