Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 970 (BODY - INTERIOR)QUARTER TRIM PANELINSTALLATION
2004 Toyota Matrix XR, FWD, Standard
Quarter Trim Panel: Installation
2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Place quarter trim panel into position (Figure).
- Reach behind trim panel, connect power outlet connector and speaker connector.
- Set locators pins into position and pressing on panel to engage the locking tabs attaching quarter trim panel body side panel.
- Install screw attaching tie down ring.
- Place quarter trim panel bolster cover (speaker grille) into position and press on bolster to engage locking pins. (Refer to SPEAKER ).
- Install C-pillar lower seat belt anchor and D-pillar lower seat belt anchor.
- Install second row seat into vehicle.(Refer to SEATS ).
- Install rear floor storage bin.(Refer to INSTALLATION ).
- Install liftgate sill scuff plate. (Refer to INSTALLATION ).
- Install rear door sill scuff plate. (Refer to INSTALLATION ).
- Open rear door and liftgate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.