SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 970 (BODY - INTERIOR)HEADLINERINSTALLATION
2004 Toyota Matrix XR, FWD, Standard

Section 970 (Body - Interior): Headliner: Installation

2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing DVD video screen bracket (Fig 3).
    1. Install u-nuts into roof bows.
    2. Place bracket into position.
    3. Install attaching screws and washers and push pins.
  2. Place headlining into vehicle through liftgate. opening.
  3. Raise headlining into position.
  4. Engage push in fasteners attaching headlining to roof panel (Fig 1) and (Fig 2).
  5. Disconnect rear view mirror wire connector from mirror.
  6. Connect wire harness connector and wire clips at the right A-pillar (Figure).
  7. Connect wire harness connectors at the left A-pillar (Figure).
  8. Install overhead DVD video screen, if equipped. (Refer to VIDEO SCREEN ).
    Fig 1: Removing Headliner Retainer Bracket
    G03571758Courtesy of DAIMLERCHRYSLER CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.