Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 970 (BODY - INTERIOR)FRONT FLOOR CONSOLEREMOVAL
2004 Toyota Matrix XR, FWD, Standard
Front Floor Console: Removal
2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Remove shift bezel. (Refer to REMOVAL ).
- Remove transmission range indicator surround bezel (Fig 1).
- Remove two screws attaching front floor console to the lower instrument panel (Fig 2).
- Open cup holder and remove two attaching screws to bottom of cup holder.
- Open bin and remove two attaching screws to bottom of bin.
- Remove front floor console sidewall attaching screws, three per side.
- Raise front floor console and disconnect wiring harness.
- Remove front floor console from vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.