Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 967 (DOOR SYSTEM - REAR)FRAME CLOSEOUT MOLDINGINSTALLATION
2004 Toyota Matrix XR, FWD, Standard
Frame Closeout Molding: Installation
2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Lower door window glass.
- Place door frame close out molding into position (Fig 1).
- Starting at C-pillar to corner and work along header to B-pillar belt line. Snapping molding into place, using hand pressure.
- Finish inserting molding along C-pillar side of door.
- Raise door window glass.
- Install door fixed glass run channel. (Refer to INSTALLATION ).
- Install rear door inner belt molding weatherstrip. (Refer to REAR DOOR INNER BELT MOLDING WEATHERSTRIP ).
- Install rear door trim panel. (Refer to INSTALLATION ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.