Section 967 (Door System - Rear): Door: Removal

2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove B-pillar upper and lower trim panel, as necessary. (Refer to B-PILLAR UPPER TRIM ) and (Refer to B-PILLAR LOWER TRIM ).
  2. Remove screws attaching door check strap to B-pillar (Fig 1).
  3. Disengage clips attaching door harness wire connector to inner B-pillar (Figure).
  4. Disconnect positive lock slide on the side of the wire connectors.
  5. Depress lock tab attaching wire connector halves together.
  6. Disconnect door harness from body wiring harness.
  7. Support door on suitable lifting device.
  8. Remove bolts attaching lower hinge to door end frame (Figure).
  9. Steady door on lifting device and remove bolts attaching upper hinge to door end frame.
  10. Remove door from vehicle.
    Fig 1: Removing Screws Attaching Door Check Strap To B-Pillar
    G03571653Courtesy of DAIMLERCHRYSLER CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.