Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 955 (EXHAUST SYSTEM)MUFFLERINSTALLATION - FRONT
2004 Toyota Matrix XR, FWD, Standard
Installation - Front
2004 Toyota Matrix XR, FWD, StandardSECTION Installation - Front
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Position the torca clamp on the catalytic converterr.
- Install the muffler into the catalytic converter until the guide pin on the converter seats into the slot on the muffler.
- Install the outlet pipe of the muffler into the inlet pipe of the resonator/muffler assembly with 45mm (.039 in.) of insertion.
- Tighten tocra clamp nut to 54 N.m (40 ft. lbs.).
- Install the resonator/muffler assembly (Refer to INSTALLATION ).
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
- Check the exhaust system for contact with the body panels. Make the necessary ajustments, if needed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.