Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 949 (CRUISE CONTROL SYSTEMS)CABLEINSTALLATION
2004 Toyota Matrix XR, FWD, Standard
Section 949 (Cruise Control Systems): Cable: Installation
2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Route cable.
- Slide speed control cable into bracket.
- Connect the vacuum line connection at rear of intake manifold.
- Install clip attaching cable to servo (Figure ).
- Install two nuts attaching mounting bracket and speed control cable to servo (Figure ). Refer to TORQUE SPECIFICATIONS for torque specifications.
- Connect electrical connectors and vacuum hose.
- Install speed control cable to throttle cam by sliding clasp into hole (Figure ).
- Install the servo bracket bolt. Refer to TORQUE SPECIFICATIONS for torque specifications.
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.