Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 946 (POWER LIFTGATE SYSTEM)FULL OPEN SWITCHINSTALLATION
2004 Toyota Matrix XR, FWD, Standard
Full Open Switch: Installation
2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Be certain the wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to components. Refer to CONNECTOR PIN-OUTS
if uncertain.
- Perform a wiring repair on the full open switch wires, or install new terminals on the wire ends and reinstall in the main drive unit electrical connector.
- Install the full open switch on the drive unit assembly.
- Connect the negative battery cable.
- Using an appropriate scan tool, check any erase any power liftgate control module diagnostic trouble codes.
- Verify power liftgate system and full open switch operation. Cycle the power liftgate through one complete open and close cycle, this will allow the power liftgate control module to relearn its cycle with the new components.
- Install the left rear D-pillar trim panel on the vehicle. Refer to D-PILLAR TRIM .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.