Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 946 (POWER LIFTGATE SYSTEM)CHIME/THERMISTORREMOVAL
2004 Toyota Matrix XR, FWD, Standard
Section 946 (Power Liftgate System): Chime/Thermistor: Removal
2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Open the liftgate.
- Disconnect and isolate the negative battery cable.
- Remove the rear light bar assembly from the vehicle. Refer to LIFTGATE for the procedure.
- Using your hands, grasp the light bar at its sides next to thermistor/chime assembly and gently pull the two sides of the light bar apart until the thermistor/chime assembly can be removed.CAUTION: Locate the wires coming from the chime/thermistor. On a piece of paper, note the wire color and cavity the wires are currently installed in on both the component and connector side of the harness. This will prove helpful later.
- Locate the wires going to the chime/thermistor. Cut the tie strap and trace the wires to the electrical connector and back the wires out of the connector. Refer to SYSTEM WIRING DIAGRAMS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.