SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 944 (LIGHTING SYSTEMS - EXTERIOR)FOG LAMP UNITINSTALLATION
2004 Toyota Matrix XR, FWD, Standard

Fog Lamp Unit: Installation

2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.

If replacing fog lamp unit with new, the fog lamp must be transferred to the new unit.

CAUTION: Do not touch the glass of fog lamps with fingers or other possibly oily surface. Reduced lamp life will result.
  1. Connect the electrical connection to the fog lamp.
  2. Make sure as you install the fog lamp unit into the fascia, the rear indexing dowels are properly lined up (Fig 2).
  3. Push the fog lamp unit straight into the front fascia.
  4. Install one retaining screw to the underside of the fascia in the fog lamp opening (Fig 1).
  5. Connect the battery negative cable.
  6. Verify vehicle and system operation
  7. Close hood.
    Fig 1: Identifying Components Of Fog Lamp Unit
    G03571517Courtesy of DAIMLERCHRYSLER CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.