Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Battery System: Description
A single 12-volt battery is standard factory-installed equipment on this model. All of the components of the battery system are located within the engine compartment of the vehicle. The battery system is comprised of the following related components, which are covered in further detail later in this article:
- Battery - The maintenance-free 12 volt automotive battery provides a reliable means of storing a renewable source of electrical energy within the vehicle.
- Battery Cables - The color-coded positive and negative battery cables connect the positive and negative battery terminal posts to the vehicle electrical system.
- Battery Holddown - The battery holddown secures the battery in the battery tray.
- Battery Thermowrap - The battery thermowarp insulates the battery from engine compartment temperature extremes.
- Battery Tray - The battery tray provides a secure mounting location in the engine compartment for the battery and an anchor point for the battery holddown.
For battery maintenance schedules and jump starting procedure, see the owner's manual in the vehicle glove box. While battery charging can be considered a maintenance procedure, the battery charging procedure and related information are located later in this section.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.