Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 937 (Clock): Description
The Analog Clock is located in the Instrument Panel Switch Pod within the instrument cluster bezel, just to the right of the instrument cluster (Fig 1 ). It is of analog type and has one adjustment button that will forward the clocks hand position.
The clock is not serviced separately from the instrument panel switch pod. If found defective, the entire switch assembly must be replaced (Refer to INSTRUMENT PANEL SWITCH POD ).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.