Cruise Control Main Switch: Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Installation is in the reverse order of removal.

  1. PRECAUTION (SEE  AIR BAG RESTRAINT SYSTEMS  ) 
  2. DISCONNECT BATTERY NEGATIVE TERMINAL (SEE  AIR BAG RESTRAINT SYSTEMS  ) 
  3. REMOVE STEERING WHEEL COVER LOWER NO.2 
  4. REMOVE STEERING WHEEL COVER LOWER NO.3 
  5. REMOVE HORN BUTTON ASSY (SEE  AIR BAG RESTRAINT SYSTEMS  ) 
  6. REMOVE CRUISE CONTROL MAIN SWITCH 
    1. Disconnect the connector.
    2. Remove the 2 screws and cruise control main switch.
      Fig 1: Removing Cruise Control Main Switch (1 Of 2)
      G03553621Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.