Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 922 (SLIDING ROOF/CONVERTIBLE)SLIDING ROOF SYSTEMINSPECTION
2004 Toyota Matrix XR, FWD, Standard
Sliding Roof System: Inspection
2004 Toyota Matrix XR, FWD, StandardSECTION Inspection
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT MOON ROOF CONTROL SWITCH
- Check the resistance between the terminals when operating the switch.
Standard:
SPECIFICATION OF RESISTANCE BETWEEN TERMINALSTerminals No. Switch Operation Specified Condition 4 - 2 TILT UP is pressed Below 1 Ω 3 - 2 SLIDE OPEN is pressed Below 1 Ω 4 - 3 OFF 10 kΩ or higher 3 - 2 OFF 10 kΩ or higher If the result is not as specified, replace the switch set.
- Check the resistance between the terminals when operating the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.