SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 910 (AUTOMATIC TRANSMISSION ASSEMBLY (ATM))SPEED SENSOR (ATM)REPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Speed Sensor (ATM): Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE AIR CLEANER ASSY (SEE  REPLACEMENT  ) 
  2. REMOVE AIR CLEANER HOSE NO.1 
  3. REMOVE AIR CLEANER BRACKET 
  4. REMOVE AIR CLEANER INLET NO.1 
  5. REMOVE SPEED SENSOR (NT SENSOR) 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and transmission revolution sensor.
      Fig 1: Removing Speed Sensor (NT Sensor)
      G03552298Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE SPEED SENSOR (NC SENSOR) 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and transmission revolution sensor.
      Fig 2: Removing Speed Sensor (NC Sensor)
      G03552299Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL SPEED SENSOR (NC SENSOR) 
    1. Coat an O-ring with ATF.
    2. Install the speed sensor with the bolt.

      Torque:  11 N.m (115 kgf.cm, 8 ft.lbf)

      Fig 3: Installing Speed Sensor Bolt
      G03552300Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      Make sure of the manufacturer's name.

    3. Connect the speed sensor connector.
  8. INSTALL SPEED SENSOR (NT SENSOR) 
    1. Coat an O-ring with ATF.
    2. Install the speed sensor with the bolt.

      Torque:  11 N.m (115 kgf.cm, 8 ft.lbf)

      HINT:

      Make sure of the manufacturer's name.

    3. Connect the speed sensor connector.
      Fig 4: Installing Speed Sensor Bolt
      G03552301Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL AIR CLEANER INLET NO.1 
  10. INSTALL AIR CLEANER BRACKET 
  11. INSTALL AIR CLEANER HOSE NO.1 
  12. INSTALL AIR CLEANER ASSY (SEE  REPLACEMENT  ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.