SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 907 (TIRE & WHEEL)WHEEL AND TIRE SYSTEMINSPECTION
2004 Toyota Matrix XR, FWD, Standard

Wheel And Tire System: Inspection

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT TIRE 
    1. Check the tires for wear and proper inflation pressure.

      Cold tire inflation pressure: 

      TIRE INFLATION PRESSURE REFERENCE TABLE

      Tire size Front kPa (kgf/cm2 , psi) Rear kPa (kgf/cm2 , psi)
      P215/60R1694V 200 (2.0, 29) 200 (2.0, 29)
      P215/55R1793V 220 (2.2, 32) 220 (2.2, 32)
    2. Using a dial indicator, check the tire runout.

      Tire runout: 1.0 mm (0.039 in.) or less 

      Fig 1: Checking Tire Runout
      G03552110Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. ROTATE TIRE 

    HINT:

    • Rotate tires as shown in Fig 2 .
    • Rotate as shown in (B) if the spare tire is included in the rotation.
      Fig 2: Rotating Tires
      G03552111Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSPECT WHEEL BALANCE 
    1. Check and adjust the off-the-car balance.
    2. If necessary, check and adjust the on-the-car balance.

      Imbalance after adjustment: 8.0 g (0.018 lb) or less 

      Fig 3: Inspecting Wheel Balance
      G03552112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSPECT BEARING BACKLASH (SEE  ON-VEHICLE INSPECTION  ) 
  5. INSPECT BEARING BACKLASH (SEE  ON-VEHICLE INSPECTION  ) 
  6. INSPECT AXLE HUB DEVIATION (SEE  ON-VEHICLE INSPECTION  ) 
  7. INSPECT AXLE HUB DEVIATION (SEE  ON-VEHICLE INSPECTION  ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.