SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 902 (O/D DIRECT CLUTCH SPEED SENSOR)O/D DIRECT CLUTCH SPEED SENSORON-VEHICLE REPAIR
2004 Toyota Matrix XR, FWD, Standard

On-Vehicle Repair

2004 Toyota Matrix XR, FWD, StandardSECTION On-Vehicle Repair
WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT EXHAUST PIPE (See  EXHAUST SYSTEM  ) 
  2. DISCONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR 
  3. REMOVE O/D DIRECT CLUTCH SPEED SENSOR 
    1. Remove the bolt and O/D direct clutch speed sensor.
    2. Remove the O-ring from the O/D direct clutch speed sensor.
  4. INSTALL O/D DIRECT CLUTCH SPEED SENSOR 
    1. Coat a new O-ring with ATF and install it to the O/D direct clutch speed sensor.
    2. Install the O/D direct clutch speed sensor to the transmission case and torque the bolt.

      Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 

  5. CONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR 
  6. INSTALL FRONT EXHAUST PIPE (See  EXHAUST SYSTEM  ) 
    Fig 1: Identifying Direct Clutch Speed Sensor
    G01317397Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.