Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fail-Safe Function
HINT:
The Headlight Leveling Control ECU performs the fail-safe when detecting following troubles.
At this it lights the warning light ("HEADLIGHT LEVELING") on the combination meter (multi-information display
| Trouble Area | System |
|---|---|
| 1. Headlight leveling actuator |
|
| 2. Vehicle speed sensor | One vehicle speed signal is 0km/h and the other is 10km/h (8 MPH) or more. |
| 3. Generator |
|
| 4. Height control sensor | Signal lever error |
| 5. Pitch angle calculation error | Signal lever error |
Recovery condition (The warning light goes off.)
- In case of 1, 2 and 3: ignition switch OFF
- In case of 4 and 5: ignition switch OFF or signal lever error cancellation
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.