Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 84 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESON-VEHICLE DEPLOYMENT (SCRAPPED VEHICLES ONLY)SIDE AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Side AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Side AIR Bag Module
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure seat back is not loose. If components are loose, remove loose components and deploy using OFF-VEHICLE DEPLOYMENT procedure. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL .
- Disconnect appropriate side air bag Yellow connector, located under seat. Connect deployment tool, using Deployment Tool Sub-Harness Adapter (09082-00750), to appropriate air bag connector. Position deployment tool at least 33 feet (10 meters) from front of vehicle. Close all vehicle doors and windows. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal of 12 volt battery.
- Ensure no one is inside vehicle or within 33 feet (10 meters) of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with deployed air bag(s) installed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.