Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 81 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENTHEAD IMPACT AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Head Impact AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Head Impact AIR Bag Module
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove head impact air bag module. See HEAD IMPACT AIR BAG MODULE under REMOVAL & INSTALLATION.
- Pass strong wire through air bag module mounting holes. See Fig 1. Position head impact air bag module inside a scrap tire with air bag deployment direction facing inside. See Fig 2. Secure head impact air bag module to tire with wire. Place this tire between 4 other tires (top tire should have wheel installed). Securely tie all tires together with wire.
- Connect Deployment Tools (09082-00700 and 09082-00760) to head impact air bag module connector. Position deployment tool at least 33 feet away from head impact air bag. Press activation switch to deploy head impact air bag. Because of heat, wait 30 minutes before handling head impact air bag. Seal deployed air bag module in vinyl bag and dispose of in usual manner.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.