Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Solar Sensor: Inspection
- REMOVE SOLAR SENSOR
Using a screwdriver, pull out the sensor, then disconnect the connector.
HINT:
Tape the screwdriver tip before use.
- INSPECT SOLAR SENSOR CONTINUITY
- Cover the sensor with a cloth, check that the no continuity exists between terminals.
If continuity exists, replace the sensor.
- Remove the cloth from the sensor and subject the sensor to electric light, check that continuity exists between terminals.
If no continuity exists, replace the sensor.
- Cover the sensor with a cloth, check that the no continuity exists between terminals.
- INSTALL SOLAR SENSOR
Connect the connector and install the solar sensor.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.