On-Vehicle Repair

2004 Toyota Matrix XR, FWD, StandardSECTION On-Vehicle Repair
WARNING: This page is about a different car, the 2004 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 AND NO. 2 ENGINE UNDER COVERS 
  2. REMOVE LH FRONT FLOOR CENTER COVER 
  3. REMOVE NO. 1 REAR FLOOR BOARD 
  4. DISCONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR 
  5. Fig 1: Disconnecting O/D Direct Clutch Speed Sensor Connector
    G00894474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE O/D DIRECT CLUTCH SPEED SENSOR 
    1. Remove the bolt and O/D direct clutch speed sensor.
    2. Remove the O-ring from the O/D direct clutch speed sensor.
  7. INSTALL O/D DIRECT CLUTCH SPEED SENSOR 
    1. Coat a new O-ring with ATF and install it to the O/D direct clutch speed sensor.
    2. Install the O/D direct clutch speed sensor to the transmission case and torque the bolt.
      1. Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 
  8. INSTALL NO. 1 REAR FLOOR BOARD 
  9. INSTALL LH FRONT FLOOR CENTER COVER 
  10. INSTALL NO. 1 AND NO. 2 ENGINE UNDER COVERS 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.