SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 792 (AUTOMATIC TRANSMISSION)FLOOR SHIFT ASSEMBLYINSTALLATION
2004 Toyota Matrix XR, FWD, Standard

Floor Shift Assembly: Installation

2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FLOOR SHIFT LEVER ASSEMBLY 
    1. Connect the 2 connectors to the floor shift lever assembly.
    2. Install the floor shift lever assembly with the 4 bolts.
      1. Torque: 8.3 N.m (85 kgf.cm, 73 in.lbf) 
      3. Fig 1: Installing Floor Shift Lever Assembly
      G00894523Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CONSOLE BOX ASSEMBLY (See  INSTALLATION  ) 
    1. Install the console box assembly.
    2. Install the parking brake hole cover assembly.
    3. Install the box bottom mat.
    4. Install the console upper panel.
  3. INSTALL NO. 1 FLOOR SHIFT GEAR SHIFTING ROD 
    1. Shift into the N position.
    2. Connect the No. 1 floor shift gear shifting rod and connecting rod swivel with the nut.
      1. Torque: 13 N.m (130 kgf.cm, 9 ft.lbf) 
  4. CHECK SHIFTING LEVER POSITION (See  PRE-CHECK  ) 
    Fig 2: Installing No. 1 Floor Shift Gear Shifting Rod
    G00894524Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.