Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Automatic Transmission Unit: Installation
- CHECK TORQUE CONVERTER CLUTCH INSTALLATION
Using calipers and a straight edge, measure from the distance from the installed surface of the transmission housing to the installed surface of the torque converter clutch.
- Correct distance: More than 0.1 mm (0.004 in.)
If the distance is less than the standard, check for an improper installation.
- INSTALL TRANSMISSION
Installation is in the reverse order of removal (See REMOVAL ).
HINT:
After installation, check and inspect items as follows.
- Adjust the shift lever position (See PRE-CHECK ).
- Fill ATF and check fluid level (See PRE-CHECK ).
- Do the road test (See PRE-CHECK ).
- Fill with engine coolant (See REPLACEMENT ).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.