Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 76 (COMPUTER RELEARN PROCEDURES - IMPORT)MAZDAKEY REPLACEMENT OR ADDITIONCUSTOMER SUPPLIED 2 OR MORE VALID KEYS
2004 Toyota Matrix XR, FWD, Standard
Customer Supplied 2 Or More Valid Keys
2004 Toyota Matrix XR, FWD, StandardSECTION Customer Supplied 2 Or More Valid Keys
WARNING: This page does not describe the selected car, but rather 164 other vehicles, including the 2002 Volvo V70, 2002 Volvo V40, 2002 Volvo S80, 2002 Volvo S60, and 2002 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Cut new transponder equipped key(s). Using first key, turn ignition switch to ON position, then LOCK position 5 times. DO NOT leave key in either position for more than one second. Turn first key to ON position. SECURITY light should illuminate. Turn first key to LOCK position and remove from ignition. SECURITY light should go out.
- Using second key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn second key to LOCK position and remove key.
- Repeat step 2 with first key. Repeat step 2 with third key. Repeat step 2 with each new or valid key, up to 8 keys total. Waiting 30 seconds will cause program to quit automatically.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.