Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fluid Temperature Sensor (Sienna): Installation
Coat a NEW "O" ring with ATF and install onto fluid temperature sensor. Install the solenoid wire and fluid temperature sensor. Install bolt and tighten to specification. See TORQUE SPECIFICATIONS . Install valve body. See SHIFT SOLENOIDS & VALVE BODY . Install connector to fluid temperature sensor. Install oil pan. Fill with correct fluid to proper level. See DRAINING & REFILLING under LUBRICATION.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.